給袋式包裝機進入我國已有數年的時間了,經過這些年的發展和追趕,雖然與國外同類產品仍舊有著不小的差距,但是已經完全能較好地滿足我國包裝產業的需求。

It has been several years since the bag packing machine entered our country. After years of development and catching up, although there is still a big gap with foreign similar products, it can fully meet the needs of our packaging industry.

1.氣路需提前準備能夠滿足計量機1立方米、儲氣罐1立方米以及冷干機1立方米的空氣壓縮機，以保證設備的正常運行。

1. The air compressor that can meet the requirements of 1 cubic meter of metering machine, 1 cubic meter of gas storage tank and 1 cubic meter of cold dryer should be prepared in advance to ensure the normal operation of the equipment.

2.電路方面根據電壓和額定功率要求準備插排和相應的三相五線電源，用于安裝使用噴碼機、計量稱重機以及啟動給袋式真空包裝機；

2. In terms of circuit, according to the requirements of voltage and rated power, the plug-in and corresponding three-phase five wire power supply are prepared for the installation and use of inkjet printer, weighing machine and start-up of bag vacuum packaging machine;

3.對于包裝醬腌菜類的產品的設備而言，其產品含鹽量高，腐蝕型強，用清水沖洗不僅可以滿足食品衛生要求，也可以降低酸堿鹽成分對設備的損傷。

3. For the equipment of packing pickle products, the product has high salt content and strong corrosion. Washing with water can not only meet the requirements of food hygiene, but also reduce the damage of acid, alkali and salt components to the equipment.

4.給袋式真空包裝機開機核對顯示屏數據，根據數值對設備的電、氣路進行檢測，壓縮空氣氣壓是否達到要求，先運轉2個工位，觀察機械有無碰擊異響。

4. Start the bag type vacuum packaging machine, check the display data, test the electric and gas circuits of the equipment according to the value, and check whether the compressed air pressure meets the requirements. First run two stations to observe whether the machine has bumping and abnormal noise.

5.打開電源開關，接通電源，預制袋就位，設定和檢查設備的溫控儀和調整主機運轉速度，先不進行上料，空轉 看空包裝袋的封口效果，如果封口效果平整無褶皺，再加。

5. Turn on the power switch, turn on the power supply, put the prefabricated bag in place, set and check the temperature controller of the equipment and adjust the running speed of the host machine. First, do not load the material, idling to see the sealing effect of the empty packaging bag. If the sealing effect is flat and without wrinkles, add.

6.在包裝過程中，質檢人員應隨時對包裝好的產品，進行抽查，看真空袋的封口是否完好，如果出現褶皺或者密封不好的現象，對設備進行及時調整，避免出現大批量的不合格品。

6. In the packaging process, the quality inspection personnel should check the packaged products at any time to see whether the sealing of the vacuum bag is intact. If there are wrinkles or poor sealing, the equipment should be adjusted in time to avoid large quantities of unqualified products.