滾揉機結構簡單，重要包括機架、滾桶、減速器、機械泵、鏈條傳動、控制家用電器等一部分組成，根據下邊文章內容大家詳盡的掌握掌握有關滾揉機的有關知識。

The structure of rolling and kneading machine is simple, including frame, barrel, reducer, mechanical pump, chain drive, control of household appliances and other parts. According to the following article, you can master the knowledge about rolling and kneading machine in detail.

1、每一次滾揉機工作上結束后，打開機械泵油氣分離器離心水泵水泵底閥電源總開關，排空儲水，清除機械泵吸入物，清除機械泵油氣分離器，保證 真空電磁閥道順暢。

1. At the end of each rolling and kneading machine operation, turn on the main power switch of the mechanical pump oil-gas separator centrifugal pump bottom valve, empty the water storage, remove the mechanical pump suction, remove the mechanical pump oil-gas separator, and ensure the smooth vacuum solenoid valve passage.

2、機械泵應每個月一次停泵檢查油的空氣污染情況，倘若機械泵外干已被空氣污染，則應該馬上換機油。換機油之前泵盡量載滿正轉15分鐘，讓油升溫后停泵旋擴大開放油塞將污油排空，用一些新油清除或用食用油高壓清洗機后導入新油?？蓞⒄铡稘L揉機真空泵常見故障與維修方法》。

2. The mechanical pump should be stopped once a month to check the air pollution of the oil. If the outside of the mechanical pump has been polluted by the air, the oil should be changed immediately. Before changing the engine oil, the pump should be fully loaded and run forward for 15 minutes as far as possible. After the oil is heated up, stop the pump and open the oil plug to drain the dirty oil. Remove the dirty oil with some new oil or use edible oil to clean the machine under high pressure and then introduce new oil. Refer to the "rolling machine vacuum pump common faults and maintenance methods.".

3、經常檢查減速器剩余油，如發現剩余油低于油位表高度1/2時要馬上添加30號潤滑油脂。

3. Check the remaining oil of the reducer frequently. If the remaining oil is less than 1 / 2 of the height of the oil level gauge, add No. 30 lubricating grease immediately.

4、滾揉機家用電器控制箱要牢固接地系統，確保用電安全。

4. The control box of household appliances of rolling and kneading machine should be firmly grounded to ensure the safety of electricity.